G06 - Cedar Bracket

CEDAR BRACKETS
Our cedar brackets are for decorative purposes. If planning to use structurally you MUST consult a professional contractor, engineer, or architect first to ensure you are ordering adequately sized brackets for your application. Also, we recommend using the professionals install method instead of our own since it will need to be specifically catered to your application. We do not load test our products but can provide cut sheets and specs on how these are constructed to your professionals so they can better understand the product and determine how to use them. If being used decoratively, however, then simply mount at the corresponding points in the diagram into load bearing studs hidden behind the wall. If masonry application, then you will need to install concrete anchors in he wall to receive the lag screws. Predrill a 3/16” hole in each spot of the bracket, then screw ¼” Timberlok lag screws through the bracket and the wall. You can sink the head of the screws 1” into the face of the bracket then fill the

hole with wood putty or conceal with a wooden plug (not included) to hide the screw head. NOTE: If used outdoors we recommend sealing the wood to minimize the chance of it cracking over time. Sealing with oil-based paints (not latex), stain, or clear sealant is preferred. Large timbers can be subjected to small cracks over time nonetheless up to 1/16” wide without compromising the product.